L Bracket Without Pre-Drilled Holes

$77.99 Canadian dollars excluding tax

SKU: LB-3-RW (Starboard) – LB-3-LW (Port)

Description

Transducer Shield & Saver LB-3 L Bracket without Pre-Drilled Holes

The LB-3 L Bracket is built using high quality aluminum alloy, is black powder coated and includes stainless steel hardware. This is a universal L Bracket which has no pre-drilled holes so that the installer can determine where it can be drilled without interfering with sliding bolts on the side of the jack plate and includes spacers that can be placed between the L Bracket and jack plate to keep the bracket away from sliding bolts. Some of the jack plates that may require this L Bracket are Pro Hi Jacker, Vance and some older jack plates. This L Bracket is not suitable for use on Atlas Jack Plates.

Please remember that a transducer cannot be attached to an L Bracket without a Transducer Shield®.

On some Skeeter boat models the turning chines and/or sponsons may interfere with the side viewing signal. For this reason it is necessary to attach an 1.5″ extension between the L Bracket and Transducer Shield®.

If you have a Bass Cat boat and your jack plate was installed by Bass Cat a 1.5″ extension is required.

Please note that when the transducer is attached to a set back, hole shot plate or the side of a jackplate, it will not track the bottom when up on plane because the transducer is out of the water. For bottom reading on plane, a transducer inside the hull will be required.

Additional information

Weight 1 lbs
Dimensions 8 × 5 × 2 in
Position/Side

Starboard / Right Side of Jackplate, Port / Left Side of Jackplate