Description

The TS-LSS-1 is built with high quality aluminum alloy and is black powder coated. It is designed to fit the Lowrance® LSS1 Structure Scan Transducer. This item does not fit the longer Lowrance® LSS2 Structure Scan transducer. Use the TS-LSS2-L if you have the longer LSS2 transducer. The sleek hydrodynamic design will cut through the water for less drag, reduces collection of debris, keeps the transducer positioned correctly and will not interfere with the transducer signal.

The TS-LSS-1 is approximately 7” long and can be installed on certain trolling motors that have a built-in sonar in the cone/bullet. If you were planning on installing this Transducer Shield® on your trolling motor but it does not have a built in sonar, then use the Transducer Shield® TS-LSS-3D.

If the installation is for a MinnKota® or Motorguide® trolling motor that is between 43 and 70 lb thrust, additional components will be required due to the size of the transducer and length of the trolling motor housing. Please call for assistance in placing your order.

The TS-LSS-1 along with additional components can easily be installed on the side of a jackplate with an L Bracket, on the hole shot plate under the jackplate with a Wedge or on the boat set back under the transom with a Wedge.

Please note that when the transducer is attached to a set back, hole shot plate or the side of a jackplate, it will not track the bottom when up on plane because the transducer is out of the water. For bottom reading on plane, a transducer inside the hull will be required.