Description

The WG-LSS2-1 wedge is built in black marine polyethylene plastic, is 10″ long x 1.5″ wide and has been designed to put the transducer at the correct angle when the boat is in the water. A transducer CANNOT be attached directly to the wedge. Please note that the WG-LSS2 wedge and Transducer Shield® assembly can be installed on a transom set-back or under a jack plate on the hole shot plate on 10″ and above jack plates only.

This wedge will fit the following Transducer Shields® :

• TS-DSS3-TS to fit Lowrance® Total Scan, 2-in-1, 3-in-1 and Structure Scan 3D
• TS-LSS2-L to fit Lowrance® LSS2 transducer
• TM-HX-3 to fit Humminbird® MSI transducer, TM-H8.3 to fit Humminbird® G2N, G3N or G4N transducer
• TG-DS-8.4, TG-DS-9 or TG-HG-8.5 Transducer Shields

The WG-LSS2 wedge is not a good candidate for jack plates that are built at a 90 degree angle with the transom (such as Atlas jack plates) or for jack plates less than 10″ wide. For these jack plates we recommend installing the Transducer Shield on the side of the jack plate by adding an L Bracket to the Transducer Shield. Choose an L Bracket to suit your Jack Plate brand and size.

Please note that when the transducer is attached to a set back, hole shot plate or the side of a jackplate, it will not track the bottom when up on plane because the transducer is out of the water. For bottom reading on plane, a transducer inside the hull will be required.