Hydraulic Steering Lock Clips 16mm - 7/8 inch

Hydraulic Steering Lock Clips 7/8 Inch

DD26 Fishing Generation 2 Mean Stops Steering interchangable clips

Our new patent pending design allows fitment for hydraulic steering systems with 3.75" and/or 4" of exposed steering rod on each side of the engine and will allow fitment with steering rods with diameters of 16mm, 3/4", 20mm and 7/8".

The way this system works is that the standard steering locks you purchased will come with the 3/4" clips attached already. Those clips result in a 4" width. Should you have a hydraulic steering system that has a different width or diameter, you simply can purchase the proper clips for your set up and switch them out at your convenience. Additional clips come in the following set ups:

• 16mm diameter providing total unit width of 3.75"
• 20mm diameter providing total unit width of 3.75"
• 7/8" diameter providing total unit width of 4"

Each of these kits comes with 4 steering lock clips.

Fitment of a hydraulic steering lock has NOTHING to do with the ENGINE itself. So if you have a Mercury Engine it has nothing to do with the steering system. Its all about which hydraulic steering system you have.

A good guide of common fitment is:

• Seastar steering systems - Usually 4" steering locks, 3/4" Diameter most common. These clips come standard with the DD26 Gen 2 Mean Stops.
• Seastar extra heavy tournament - Usually 4" steering locks with 7/8" diameter
• Baystar steering systems - Usually 3.75" steering locks with 16mm Diameter
• Mercury steering systems - Usually 3.75" steering locks with20mm Diameter
• Uflex steering systems - Usually 3.75" steering locks with 20mm Diameter Measure first

These second generation clips do not fit first generation Mean Stops!