Languages / Langues:
English / Anglais
French / Francais

Troll-A-Matic Trolling Plate - T&L Products


Automatic Trolling Motor Plate
by T&L Products of Michigan

Item# TAM

Proven Performance
Fully automatic
No rust or corrosion
Glass filled nylon construction

Speed Matters
Fishermen know trolling speed is crucial
Automatically swings up as speed is increased
Works on most outboards and inboard drive 50 hp or higher
(check size for compatibility on smaller outboards)

Easy to Install
Mounts in minutes
Simply drill four ¼’’ holes
Stainless steel hardware included


This revolutionary trolling device allows you to operate your motor at a wide range of speeds from very slow to wide-open. Plus, it's completely automatic and swings up as speed is increased, so there is absolutely no interference. Constructed of fiberglass-filled nylon, it will not rust or corrode. Works on most outboards or inboard out-drives from 50 hp on up. Mounts in just minutes. Not for use with Volvo out-drives.

Troll-A-Matic specifications:

Bolt hole pattern (center to center): 5.063 in. on holes
near the plate, 4.5 in. on the other.
Hole spacing (center to center), front to rear: 1.875 in.
Plate (in.): 11.75 wide x 13.62 high from pivot pin
Mounting hardware included (no instructions necessary)
Mounts to bottom of cavitation plate.
Springs allow plate to hinge upward under full throttle.
Unit does not lock into a fully-horizontal position.
This item will not fit on Volvo outdrives because of the
shape of the outdrives lower unit.
This trolling plate is not compatible with motors using a
dual-propeller configuration.

Customers Who Bought This Item Also Bought
Educational DVD's
  Doctor Sonar
Easily Remove Lowrance
Power, Sonar and Ethernet Cables

Trusty Cable Tool

Fish Finder
Screen Cleaning Kit

Solution Graphics

PayPal Acceptance Mark


Website Builder