Automatic Trolling Motor Plate by T&L Products of Michigan
This revolutionary trolling device allows you to operate your motor at a wide range of speeds from very slow to wide-open. Plus, it's completely automatic and swings up as speed is increased, so there is absolutely no interference. Constructed of fiberglass-filled nylon, it will not rust or corrode. Works on most outboards or inboard out-drives from 50 hp on up. Mounts in just minutes. Not for use with Volvo out-drives.
Proven Performance
- Fully automatic
- No rust or corrosion
- Glass filled nylon construction
- Fishermen know trolling speed is crucial
- Automatically swings up as speed is increased
- Works on most outboards and inboard drive 50 hp or higher (check size for compatibility on smaller outboards)
- Mounts in minutes
- Simply drill four 1/4" holes
- Stainless steel hardware included
- Bolt hole pattern (center to center): 5.063 in. on holes near the plate, 4.5 in. on the other
- Hole spacing (center to center), front to rear: 1.875 in
- Plate : 11.75 in. wide x 13.62 in. high from pivot pin
- Mounting hardware included (no instructions necessary)
- Mounts to bottom of cavitation plate
- Springs allow plate to hinge upward under full throttle
- Unit does not lock into a fully-horizontal position
- This item will not fit on Volvo outdrives because of the shape of the outdrives lower unit
- This trolling plate is not compatible with motors using a dual-propeller configuration
